Printek Paper Throat and Sensor, FormsPro 4600, 4603

The Printek Paper Throat and Sensor is a repair part for the Wide Carriage Dot Matrix Printer models FormsPro 4600 and FormsPro 4603.

Replacement Instructions - Paper Throat and Sensor:

1. Remove the electronics cover.
2. If installed, remove the ImagerPlus Graphics Interface.
3. Unplug the paper sensor.
4. Remove the two screws that attach the top sides of the throat to the paper exit extrusion.
5. Remove the three screws and flat washers that attach the bottom of the throat to the chassis.
6. Open the printer case and remove the throat from the bottom of the case.
7. Loosely install the new throat/sensor assembly with the hardware removed earlier.
8. Align the paper out sensor and throat assembly.

×

×

×

×

×

×